• TDD OFDM wireless video data transceiver support Mesh Networking
• Up to 100Mbps Iperf Throughput
• Control by web browser or control UART
• 3 Ethernet and 1 channel RS232/TTL for data link
• Maximum 50km long distance fhss video data links for UAV/ UAS
• FHSS makes signal communication to be secure and more stable.

HCL602-2W*2-M3 Mesh networking transceiver supports mesh network with maximum 32 nodes and shared maximum 100Mbps Iperf Throughput.

1. Mesh network capacity: supports a maximum of 32 Nodes (2≤N≤32)
2. Transport: unicast, multicast, and broadcast are supported
3. Time synchronization: self-synchronization without external clock
4. Power control: adaptive transmission power adjustment
5. Topology: supports multi-hop routing with maximum 32 nodes and 31 hop routing
6. Routing: automatic routing adjustment with fixed route configuration option
7. Data rate level: adaptive average distribution system rate
8. Transmission delay(Note: N is the number of nodes within two hops, hop number: H)
   • Common scenario calculation formula, One-way delay indicator formula (MS): 6*H + (5/2) * N/2 *H * 3, Two-way delay multiplied by 2;
   • Two-node optimization delay: unidirectional delay of one hop between two nodes <= 10ms;
   • Four node chain optimization delay: three-hop single-hop unidirectional delay of four nodes <= 10ms;
   • Typical system delay(from big data statistics):
     • Six point-chain networking, three hops, unidirectional delay: 50ms;
     • 8 points, all points one hop, one-way delay: 36ms;
     • 8 points, serial 7 hops: unidirectional 170ms
9. Boot time delay:
   • Network establishment delay of logical main control node after startup 20-80s. (Generally, the logical main control node is the node which turned on firstly);
   • Cold startup: The network access delay of the logic access node is less than 30 seconds, and the logical main control node signal is received;
   • Hot startup: The latency of connecting the secondary node to the network is less than 1s (common one-hop node networking scenario)

Q1: Does this Mesh networking transceiver support any other cameras except IP camera?

A1: IP camera video can be connected with HCL602-2W*2-M3 directly via Ethernet port. HDMI/SDI/AHD/AV camera video can be encoded with our SE10/SE11 encoder and then work with HCL602-2W*2-M3 via Ethernet connection.